Miller 302 Air Pak Problems Serial Number And
Miller 302 Air Pak Problems Generator Fuel Welding

NPT swivel fitting (Miller Part No. 300 571). 804 953-A WM Design OM-229 930 Page 29.

Thats why when Niels Miller first started building arc welders in 1929, he made sure his products offered long-lasting value and superior quality.

The possible hazards are shown in the adjoining symbols or explained in the text.

Breathing these D Do not weld where the atmosphere may contain flammable dust, fumes and gases can be hazardous to your health.

D Always wear a face shield, rubber gloves, and protective clothing when working on a battery.

D Do not touch hot compressor or air system D Keep away from fans, belts and rotors.

D Keep all doors, panels, covers, and guards D Let system cool down before touching or ser- closed and securely in place.

D High-frequency (H.F.) can interfere with radio D Electromagnetic energy can interfere with navigation, safety services, computers, and sensitive electronic equipment such as micro- communications equipment.

D Les fumes dun groupe autonome contient du D Remplacer une batterie endommage.

D Lire le manuel dutilisation avant dinstaller, dutiliser ou dintervenir sur lappareil.

D Effectuer lentretien en respectant les manuels dutilisation, les normes industrielles et les codes nationaux, dtat et locaux.

Garder les cbles ensemble, les torsader, les scotcher, ou les champs magntiques et lectriques.

Symbol Definitions Fast FastSlow Stop Engine Slow (Idle) (Run, WeldPower) (RunIdle) Start Engine PanelLocal Temperature Fuel Check Valve Engine Oil Engine Choke Battery (Engine) Clearance Read Operators Engine Amperes Volts Manual MIG (GMAW), Stick (SMAW) TIG (GTAW) Lift Arc TIG Wire.

Miller 302 Air Pak Problems Generator Fuel Welding

Weld, Power, And Engine Specifications Rated Maximum Welding Weld Generator Fuel Welding Open-Circuit Engine Mode Output Range Power Rating Capacity Output Voltage 280 A, 32 V, 100 CCDC 10 300 A Duty Cycle Kohler CH-750 Continuous: 11 kVAkW, Air-Cooled, 300 A, 32 V, 100.

Tools and motors are designed to operate within 10 of 120240 VAC.

WATTS AC AMPERES 235 695-A 4-7.

Duty Cycle Duty cycle is the percentage of 10 100 Duty Cycle at 280 Amperes DC minutes that unit can weld at rated.

CCDC Stick Mode The volt-ampere curves show the minimum and maximum voltage and amperage output capabilities of the welding generator.

AC AMPERES B. CCDC TIG Mode DC AMPERES 235 698-A 235 699-A OM-229 930 Page 21.

Miller 302 Air Pak Problems Serial Number And

Serial Number And Rating Label Location The serial number and rating information for this product is located on the rear panel.

For future reference, write serial number in space provided on back cover of this manual.

Also see AWS Safety Health Fact Sheet No.

Grounding of Portable And Vehicle Mounted Welding Generators.

Optional Oil FillCheck Keep oil level threaded area of fill pipe.

High oil temperature on dipstick, add oil (see compressor main- and on a level surface.

Tools Needed: 12 in.

Ref. 229 219-A Ref.

S-0756-D 804 953-B 5-7.

Work Weld Output Terminal StickTIG (CC) Weld Output Terminal Wire (CV) Weld Output Terminal For MIG welding, connect work cable to Work terminal and wire feeder cable to Wire (CV) terminal.

A WM Design OM-229 930 Page 29.